Dulux Trade Diamond Glaze Varnish Gloss

Diamond Glaze from Dulux Trade is a water-based maximum durability interior clear wood varnish. It is a simple one pack system and is ideal for use on wooden floors and other high wear interior wood surfaces. It is up to ten times tougher than conventional varnish* and is resistant to common chemicals, alcohol and hot water. Suitable for use over cork tiles, hardboard and chipboard etc.

Brush or short pile mohair roller only. Do not spray.

STIR THOROUGHLY BEFORE USE, taking care not to use a whipping motion, which will introduce air and cause foaming when applied. Apply 2 or 3 coats of Diamond Glaze Varnish from Dulux Trade using either a brush or short pile mohair roller. Apply evenly and consistently, taking care to keep the 'wet edge' alive and finish off along the grain. Apply a small test area first to check adhesion and appearance. When recoating allow at least 2 hours between coats. Rub down lightly along the grain between coats using a fine grade adhesive paper. Before using coloured Diamond Glaze Varnish from Dulux Trade on base wood, pre-seal with a coat of Diamond Glaze Varnish from Dulux Trade Clear Gloss to minimise colour absorption differences.
Apply 1-2 coats of coloured Diamond Glaze Varnish from Dulux Trade to achieve the desired depth of colour. For further protection, without deepening the colour, a finishing coat of Diamond Glaze Varnish from Dulux Trade in Clear Gloss or Satin may be applied. After use, remove as much Diamond Glaze Varnish from Dulux Trade in Clear Trade in Clear Gloss or Satin may be applied. After use, remove as much Diamond Glaze Varnish from Dulux Trade as possible from equipment before cleaning with water.


Do not use below 10ºC or in areas of high humidity or condensation. Very hot objects such as bottles, coffee pots etc. should not be placed directly on top of Diamond Glaze Varnish from Dulux Trade coated surfaces. Surfaces should be protected from water, steam, spillages and hard stress (such as abrasion or polishing) for a minimum of 5 days after application. With careful occupation, light foot traffic is allowed after 24 hours but to prevent possible damage to floor while the full mechanical resistance develops, avoid heavy wear and do not replace carpet or rugs or move furniture for at least 7 days after application. Contact the Dulux Technical Advice Centre on +353 21 422 0222 for further information.